Flag With Rope And Toggle

Feed the loop through the eye of the snap hook.

Flag with rope and toggle.

The small loop will grow tighter with each pull of the halyard. Pull the hook part through the loop and tighten the rope to the body of the hook. You want to create an endless length of halyard. Flags with grommets these are round and solid brass that are placed usually on the header of the flag one at the top and one at the bottom.

Push the toggle through the loop that was made in the halyard and make sure it is secure. On a flag with a rope and toggle the toggle is usually on the top of the flag tie the rope from the bottom of the flag to the other end of the halyard. The flag should form part of a continuous loop with the halyard rope on the flagpole. If you are flying the union jack flag it is important that your display it the correct way up.

The flag should be attached to its left hand side with a heading line and toggle. Rope toggle for 18 x 36 flags toggle specs. Stretch the flag down the rope to measure where the bottom snap hook should be placed. When looking at the front of the flag the flag should facing to the right of the flagpole.

1 2 cm end diameter. The toggle denotes the top of the flag and a short length of line or rope comes out of the bottom of the flag heading.