Finding Break In Invisible Fence With Am Radio

This product is not effective for finding partial or decaying breaks.

Finding break in invisible fence with am radio.

The kit includes a mini transmitter and an am radio. Don t have a wire locator. Unplug your dog fence transmitter. Set a portable am radio to am 60 or am 600.

If the instructions are unavailable turn on a portable am radio near the fence transmitter. Hooking up to both fence wires will send a signal up both sides of the break making it much harder to detect. Save the 70 and make your own diy locator using an am radio. When standing over the twisted wire the signal should be absent.

Hold the radio chest high and swing the radio over the wire while walking around the boundary. Fourth use an am radio most types of fence use an am signal including if brand not a fm signal and walk the wire listening for the tone. With close to 2000 of wire i started on the end that seemed the most vulnerable i found the break about 150 from the opposite end where the kids buried a dead bird. The wire breaks must be clean breaks.

Plug in the sending unit so that both lights on the transmitter are lit. Ground the sending unit by attaching the enclosed wire to the center screw of an electrical outlet. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Turn on the am radio turning the station to 530 khz.

This usually is an am frequency on the lower end of the spectrum. Search the am stations until you have found the correct one. How to find break in invisible fence using an am radio. Set the field width knob on the wall transmitter at the minimum level to obtain a signal on the portable radio.

When the tone stops that may be the break. Turn off your dog fence transmitter. The hard part was finding an am fm radio got stuck walking around with a hulking desktop radio from target. Connect your wire break locator to your twisted wire.

Find the radio frequency that your invisible fence is using. Check your fence instructions for the exact frequency. What you are doing here is making a diy wire locator using a lawnmower as a transmitter a wire to connect the transmitter to the underground cable and the am radio to find where the wire is located. Hopefully the break will be in the same spot unless you have multiple breaks.